Line an area with wallpaper and you’ve got instant decoration. From blah to daring in a matter of hours, paper can push boundaries outside what paint can do. It enlivens walls with stripes or patterns or your pick.
But as frequently as homeowners attempt to hang paper themselves, they seldom get it right, cursing their paring tiles and mismatched patterns–it’s enough to drive you up a wallsocket. Input John Gregoras, a pro paper hanger from Somers, New York, with nearly two decades’ experience. And, boy, did we learn a great deal – everything from the way he intends the design to how he lines up the last seam. With this kind of insider know-how, papering only got a whole lot simpler.
Best Wallpaper Techniques Overview
Design is the key if you are learning how to hang wallpaper. Paying attention to the order where the newspaper goes up ensures your pattern will stay well-matched and seem straight. John Gregoras recommends working in 1 direction around the room to keep the pattern consistent.
But no matter how good your strategy, the pattern between the first and final strip will rarely match up. Because of this, Gregoras always starts his job behind a door, papering from the corner until he reaches the space over the door– at the least conspicuous place in the room.
Very often, the last strip of paper onto a wall isn’t a full sheet. So another wallpapering tip Gregoras uses is to constantly paper the corners together with broken sheets.
Click button on top right to enlarge case.
Apply Wallpaper Paste
Paint the entire room with a wall primer/sizer.
Unroll the wallpaper. As you do, check out flaws and haul the paper from the edge of your worktable to remove the curl.
Cut in the exact same region on the repeat so patterns on adjoining sheets will line up.
Lay a cut sheet on the desk, face down. With a paint roller, apply a thin film of clear premixed background paste on the back of the newspaper.
Suggestion: Do not allow paste to have on the desk or it will mar the next sheet (wash it off with a barely damp sponge when it does). Slide the paper all the way into the border of this table to use paste to the ends and borders.
Novel the Paper
Twist the pasted back of the paper on it, bottom and top ends assembly in the middle. Make sure the side edges line up perfectly. Smooth the paper on itself as much as possible without creasing the folds.
Place the paper aside to permit the paste to soak in and the paper to relax. Be sure to follow the precise booking time advocated on the wallpaper’s tag, which differs depending on its material (much more for vinyl-coated wallcoverings, less for uncoated papers).
Start at a corner near your door. In case the doorway is far from the corner, then draw a reference line parallel to the doorway near the corner.
Overlap roughly 2 inches in the ceiling and 1/8 inch in the corner. Gently press it in position.
Unfold the bottom of the novel and let it hang. Check the measurement between the paper and the door casing or benchmark line. Adjust the paper to keep it parallel to the door but still overlapping at least ⅛ inch in the corner.
Tuck and Trim the Paper
When the sheet is aligned, use the edge of a paper simpler to tuck the paper to the corner in the ceiling. (Don’t press so hard for you to push out glue.)
Trim the excess paper at the ceilingPush a 6-inch taping knife into the joint between the wall and ceiling. With a razor, cut over the knife to cut the surplus. Work slowly. Alternate between moving and cutting the knife. Don’t slide the knife and razor together roomgood.ru. Continue papering to a point over the door.
Continue Papering
On the adjoining wall, then draw a plumb line (if there is no door or window).
Hang a strip in the corner. Overlap the present bit on the adjacent wall by 1/8 inch. Quantify to the plumb line and correct the paper to maintain the distance equivalent. Smooth the newspaper. Lean in the ceiling and cut on the corner.
Hang another strip of paper. Unfold the surface of the novel and place it at the wall. Match the pattern as tightly as you can, leaving just a hair’s width between sheets.
Tip: Push air bubbles out by sweeping the paper simpler from the center out to the edges. Wipe off paste on the surface using a sponge.
Close to the Seams
Gently press on the surface of the paper into the wall. Then lightly roll the seam with a seam roller to flatten down the edges.
Unfold the bottom of the sheet and complete matching and shutting the seam. Then tightly roll the whole seam, working a full 3 inches from the edge.
Smooth the entire sheet. Continue papering the space, trimming and overlapping corners as shown in Step 5.
Tip: If the reserved end of this strip starts to dry out until you hang it, wipe the wall with a damp sponge. This will remoisten the paste when you hang the paper.
Cut in Around Moldings
At doors and windows, allow the paper float the molding by at least an inch.
Together with the razor, make a relief cut in the paper. Carefully run the razor out of the molding corner out to the border of this paper. Utilize the molding for a guide.
Press the cut edge tight in the joint between the molding and the wall.
Smooth down the entire sheet.
Suggestion: Mistakes are unavoidable when you’re learning how to hang wallpaper. Hide small cutting errors on darker papers by coloring the wall or the white border of the paper using a mark that matches the paper. Some pros even colour all the paper’s borders so seams are not as evident should the paper shrink as it dries.
Cover Switch
Paper the cover plates of electrical fixtures to make them disappear. Cut a piece of wallpaper bigger than the plate. Cut out of the component of the pattern that matches the paper onto the wall around the switch.
Hold them both on the wall and adjust the paper to match the pattern on the wall.
Hold the paper and then turn the plate . Cut off the corners 1/8 inch off from the plate. Wrap the paper above the plate and then tape it on.
Cut out the change or receptacle holes with a razor. Make Xs at the screw holes. Screw the plates back to the wall.